OXSILAN MM 0705

If breathed in, move person into fresh air. If breathing is irregular or stopped, administer artificial respiration. If symptoms persist, call a physician.

Immediately remove contaminated clothing. Wash off immediately with soap and plenty of water while removing all contaminated clothes and shoes. Do NOT use solvents or thinners. If symptoms persist, call a physician.

Symptoms: May cause an allergic skin reaction.

If easy to do, remove contact lens, if worn. Call a physician immediately. Immediately wash affected eyes for at least 15 minutes under running water with eyelids held open, consult an eye specialist.

Symptoms: Causes serious eye damage.

Rinse mouth. Do NOT induce vomiting. If symptoms persist, call a physician.

Water spray jet, Dry powder, Alcohol-resistant foam, Carbon dioxide (CO2)

High volume water jet

Hazardous decomposition products formed under fire conditions.

Cool containers/tanks with water spray.

Avoid breathing vapours. For non-emergency personnel: Use personal protective equipment. Ensure adequate ventilation, especially in confined areas. Keep away from sources of ignition. For emergency responders: Advice on product handling can be found in sections 7 and 8 of this safety data sheet.

If the product contaminates rivers and lakes or drains inform respective authorities. Avoid subsoil penetration. Do not allow uncontrolled discharge of product into the environment.

soak up with non-combustible absorbent material

Materials: sand, earth, diatomaceous earth, vermiculite

Avoid contact with the skin, eyes and clothing. Do not breathe vapors or spray mist. Handle in accordance with good industrial hygiene and safety practice. Do not return residues to the storage containers.

Store protected against freezing. Keep away from heat. Avoid direct sunlight. Close containers carefully once opened and store them upright in order to prevent any leakage. No smoking. No admission for unauthorised personnel. Always keep in containers of same material as the original one. Observe label precautions. Keep in a dry, cool and well-ventilated place.

Smoking, eating and drinking are forbidden in application area. Remove contaminated clothing immediately and dispose of safely. Wash hands before breaks and at the end of workday. Keep away from food, drink and animal feedingstuffs.

Avoid all sources of ignition: heat, sparks, open flame. Product may charge electrostatically: always use earthing leads when transferring from one container to another and earth containers. It is recommended that operators should wear antistatic clothing and footwear.

Ensure adequate ventilation.

The selected protective gloves have to satisfy the specifications of Regulation (EU) 2016/425 and the standard EN 374 derived from it. nitrile rubber (NBR) - 0.4 mm coating thickness butyl rubber gloves - material thickness: 0.5 mm Performance level 6, corresponding to a breakthrough time of >480 min according to EN ISO 374-1 The protection glove should be tested for its specific suitability (e.g. mechanical strength, product compatibility, anti-static properties). Gloves should be discarded and replaced if there is any indication of degradation or chemical breakthrough.

Tightly fitting safety goggles (splash goggles) (e.g. EN 166)

Filter type : Organic vapor Type (A). If these are not sufficient to maintain concentrations at the workplace below the occupational exposure limits, appropriate certified respirators must be worn.

Chemical resistant protective clothing according to DIN EN 13034 (Type 6)

No decomposition if stored and applied as directed.

No dangerous reaction known under conditions of normal use.

No hazardous reactions when stored and handled according to instructions.

Avoid direct sunlight. Heat.

Keep away from oxidizing agents, strongly alkaline and strongly acid materials in order to avoid exothermic reactions.

No decomposition if stored and applied as directed.

Observe national and local legal requirements.