Ethanol 96 % denatured with IPA, MEK and Bitrex

Supply fresh air; consult doctor in case of complaints.

Symptoms: Dizziness

Wash off with plenty of water. Immediately remove any clothing soiled by the product. If skin irritation continues, consult a doctor.

Symptoms: Irritation to skin

Call a doctor immediately.

Symptoms: Irritation to eyes

make victim drink water (maximum of 2 drinking glasses). Seek medical treatment.

Symptoms: Nausea

CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.

Combustible. Forms explosive mixtures with air at ambient temperatures. Vapours are heavier than air and may spread along floors. Beware of backfiring. Forms explosive mixtures with air on intense heating.

Wear protective equipment. Keep unprotected persons away. Avoid substance contact. Do not inhale steams/aerosols.

danger of explosion! Do not allow to enter sewers/ surface or ground water.

Clean up affected area.

Materials: liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust)

Keep away from heat and direct sunlight. Work only in fume cupboard. Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols. Ensure good interior ventilation, especially at floor level. (Fumes are heavier than air). Keep ignition sources away - Do not smoke. Protect from heat. Protect against electrostatic charges.

Keep away from heat and direct sunlight.

Keep ignition sources away - Do not smoke. Protect from heat.

No further data; see item 7.

The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Material of gloves: The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. Penetration time of glove material: The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed. For the permanent contact gloves made of the following materials are suitable: Butyl rubber, BR. Recommended thickness of the material: ≥ 0.7 mm. Value for the permeation: Level ≥ 480 min. As protection from splashes gloves made of the following materials are suitable: Nitrile rubber, NBR. Recommended thickness of the material: ≥ 0.11 mm. Value for the permeation: Level ≥ 480 min.

Tightly sealed goggles

In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device. Use suitable respiratory protective device only when aerosol or mist is formed. Recommended filter device for short term use: Filter AX

Solvent resistant protective clothing. Flame retardant antistatic protective clothing

No decomposition if used according to specifications.

Forms explosive gas mixture with air.

Reacts with strong acids. Reacts with oxidising agents. Forms explosive gas mixture with air.

Danger of receptacles bursting because of high vapour pressure when heated. Forms explosive gas mixture with air.

alkali metals, alkaline earth metals

In the event of fire: See chapter 5

Chemicals must be disposed of in compliance with the respective national regulations.

Must not be disposed together with household garbage.

Warning: Flammable liquids.

Warning: Flammable liquids.

Warning: Flammable liquids.