FORM POLYFLEX

Use alcohol resistant foam, carbon dioxide, or dry chemical extinguishing agents. Water may be ineffective but water spray can be used extinguish a fire if swept across the base of the flames. Water can absorb heat and keep exposed material from being damaged by fire. Regular foam

No data available

Vapours may be ignited by sparks, flames or other sources of ignition if material is above the flash point giving rise to a fire (Class B). vapours are heavier than air and may travel to a source of ignition and flash back.

Fight fire from a safe distance and a protected location. Water may be used to cool closed containers to prevent pressure build-up and possible auto ignition or explosion when exposed to extreme heat.

Non-emergency personnel should be kept clear of the area. Emergency responders: No health affects expected from the clean-up of this material if contact can be avoided. Follow personal protective equipment recommendations found in Section 8 of this SDS

Refer to information provided for large spills

No special spill clean-up considerations. Collect and discard in regular trash. Use an inert absorbent such as sand or vermiculite. Place in properly labeled closed container. Avoid breathing vapors. All personnel in the area should be protected as in Section 8. Activate available exhaust ventilation equipment in the immediate spill area. Shut off ignition sources; including electrical equipment and flames. Do not allow smoking in the area.

No data available

Collect and discard in regular trash. Use an inert absorbent such as sand or vermiculite. Place in properly labeled closed container.

Materials: sand or vermiculite

Mildly irritating material. Avoid unnecessary exposure. Keep out of the reach of children. Keep container closed when not in use. Do not take internally. Avoid contact with material, avoid breathing dusts or fumes, use only in a well ventilated area. Use with adequate ventilation. Do not get in eyes, on skin and clothing. All hazard precautions given in the data sheet must be observed.

Store in a cool dry ventilated location. Isolate from incompatible materials and conditions. Keep container(s) closed. Avoid contact with incompatible materials. Store in a tightly closed container Keep away from heat, sparks, and flame For maximum product quality, avoid prolonged storage at temperatures above 75 °F (25 °C).

Wash hands before eating

Keep away from heat, sparks, and flame

No exposure limits exist for the constituents of this product. Use local exhaust ventilation or other engineering controls to minimize exposures and maintain operator comfort.

Protective gloves are recommended when prolonged skin contact cannot be avoided. Gloves should be made of neoprene or natural rubber.

Wear chemically resistant safety glasses with side shields when handling this product. Do not wear contact lenses. Splash proof chemical goggles are recommended to protect against the splash of product.

Respiratory protection may be required to avoid overexposure when handling this product. General or local exhaust ventilation is the preferred means of protection. Use a respirator if general room ventilation is not available or sufficient to eliminate symptoms. Use a NIOSH approved respirator designed to remove particulate matter and organic solvent vapors.

Not normally considered a skin hazard. Where use can result in skin contact, wear a barrier cream and/or impervious surgical style gloves. To prevent repeated or prolonged skin contact, wear impervious clothing and boots. Protective gloves and proper clothing should be worn to prevent skin contact.

Stable under normal handling conditions

Not expected to be reactive

None expected under standard conditions of storage

No data available

Peroxides, Strong acids, Strong oxidizing agents, Polymerization catalysts

Carbon dioxide, Carbon monoxide, Styrene oxide, Hydrocarbons

Spent or discarded material is a hazardous waste.