RESION MEKP Hardener

Upon breathing difficulties or irritation of the respiratory tract: Bring the person into fresh air and stay with him/her.

Symptoms: irritation of the respiratory tract

Flush exposed area with water for a long time – at least 30 minutes. It may be necessary to flush for several hours. Use a comfortable water temperature (20-30 °C). Contact Poison Information/doctor/hospital for further advice on follow-up and treatment. Upon irritation: rinse with water. In the event of continued irritation, seek medical assistance.

Symptoms: skin corrosive properties, irreversible effects

If in eyes: Flush eyes with plenty of water or salt water (20-30 °C) for at least 30 minutes and continue until irritation stops. Remove contact lenses. Make sure you flush under the upper and lower eyelids. Seek medical assistance immediately and continue flushing during transport.

Symptoms: irreversible effects

In the case of ingestion, contact a doctor immediately. If the person is conscious, give them water. DO NOT try to induce vomiting unless this is recommended by a doctor. Hold head facing down to prevent vomit from returning to the mouth and throat. Prevent shock by keeping the injured person warm and calm. Initiate immediate resuscitation if breathing stops. If unconscious, roll the injured person into recovery position. Call an ambulance.

Alcohol-resistant foam, carbon dioxide, powder, water mist.

Waterjets should not be used, since they can spread the fire.

Fire will result in dense smoke. Exposure to combustion products may harm your health.

Closed containers, which are exposed to fire, should be cooled with water.

Storages not yet ignited must be cooled by water mist. Remove flammable materials if conditions allow it. Ensure sufficient ventilation. Avoid direct contact with spilled substances. Ensure adequate ventilation, especially in confined areas. Contaminated areas may be slippery.

Avoid discharge to lakes, streams, sewers, etc.

Limit spillage and collect using granular absorbent or similar materials. Contain and collect spillage with non-combustible, absorbent material. Cleaning should be performed with normal cleaning agents.

Materials: granular absorbent or similar materials, sand, earth, vermiculite or diatomaceous earth

Ground and bond container and receiving equipment. Avoid direct contact with the product.

Containers that have been opened must be carefully resealed and kept upright to prevent leakage. Must be stored in a cool and well-ventilated area, away from possible sources of ignition. Dry, cool and well ventilated.

Smoking, drinking and consumption of food is not allowed in the work area.

Away from possible sources of ignition.

Ground and bond container and receiving equipment. The formation of vapours must be kept at a minimum and below current limit values. Installation of a local exhaust system if normal air flow in the work room is not sufficient is recommended. Ensure eyewash and emergency showers are clearly marked. Ensure that eyewash stations and safety showers are located within easy reach.

Material: Butyl, Glove thickness: 0,3 mm, Breakthrough time: > 480 min., Standards: EN374-2, EN374-3, EN388

Type: Face shield alternatively safety glasses with side shields., Standards: EN166

Type: Combination Filter A2B2E2K2, Class: Class 2 (medium capacity), Colour: Brown/Gray/Yellow/Green, Standards: EN14387

No special when used as intended

Keep damming materials near the workplace. If possible, collect spillage during work.

The product is stable under the conditions, noted in section 7 “Handling and storage”.

No data available.

None known.

Avoid static electricity.

Strong acids, strong bases, strong oxidizing agents, and strong reducing agents.

Thermal decomposition may produce corrosive vapours.

Dispose of contents/container to an approved waste disposal plant.

Dispose of contents/container to an approved waste disposal plant.