Tandemol H 674 I-LV

Move to fresh air.

Wash off immediately with soap and plenty of water. Remove and wash contaminated clothing before re-use.

Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Keep eye wide open while rinsing. Do not rub affected area. Seek immediate medical attention/advice.

Symptoms: Eye damage/irritation

Clean mouth with water. Drink plenty of water. Do not induce vomiting without medical advice.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment; Use CO2, dry chemical, or foam, Water spray or fog, Cool containers / tanks with water spray

Do not use a solid water stream as it may scatter and spread fire

In the event of fire and/or explosion do not breathe fumes. Carbon monoxide, carbon dioxide and unburned hydrocarbons (smoke). Thermal decomposition can lead to release of irritating gases and vapors.

Remove all sources of ignition. Ensure adequate ventilation. Use personal protective equipment. Avoid contact with skin, eyes and clothing. Evacuate personnel to safe areas.

Dike to collect large liquid spills.

Prevent further leakage or spillage if safe to do so.

Soak up with inert absorbent material

Materials: sand, silica gel, acid binder, universal binder, sawdust

Keep away from open flames, hot surfaces and sources of ignition. Handle in accordance with good industrial hygiene and safety practice. Ensure adequate ventilation. Do not eat, drink or smoke when using this product. Wear personal protective equipment. Avoid contact with skin, eyes and clothing.

Keep containers tightly closed in a dry, cool and well-ventilated place.

Handle in accordance with good industrial hygiene and safety practice. Do not eat, drink or smoke when using this product.

Keep away from open flames, hot surfaces and sources of ignition.

Ensure adequate ventilation, especially in confined areas. Eyewash stations.

For operations where prolonged or repeated skin contact may occur, impervious gloves should be worn. The following glove type may be suitable for handling this product: Protective gloves complying with EN 374. Nitrile rubber Glove thickness => 0.38 mm Break through time => 480 min Butyl rubber Glove thickness => 0.64 mm Break through time => 480 min Glove material suitability will vary depending on specific use conditions. Consideration should be given to variables such as operational characteristics, anticipated contact time, task requirements and other factors relevant to the selection of PPE. Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion. Any specific glove information provided is based on published literature and glove manufacturer data. Barrier creams may help to protect the exposed areas of skin. Barrier creams should not be applied after exposure has occurred. Gloves should be replaced regularly and if there is any sign of damage to the glove material.

Tightly fitting safety goggles. Eye protection must conform to standard EN 166.

No special protective equipment required. In case of mist, spray or aerosol exposure wear suitable personal respiratory protection and protective suit.

Long sleeved clothing.

No special environmental precautions required.

Stable under normal conditions

None under normal use conditions

None under normal use conditions

Keep away from open flames, hot surfaces and sources of ignition. Extremes of temperature and direct sunlight.

Strong oxidizing agents, Strong acids, Strong bases

Incomplete combustion and thermolysis produces potentially toxic gases such as carbon monoxide and carbon dioxide.