LOCTITE STYCAST US 5536 PTA known as HYSOL US5536 PART A 5 GAL

Move to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention.

Symptoms: Asthmatic-type symptoms may develop and may be immediate or delayed up to several hours. Extreme asthmatic reactions can be life threatening.

Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothing and footwear. If symptoms develop and persist, get medical attention. Wash clothing before reuse.

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Get medical attention.

Symptoms: Workplace vapors have produced reversible corneal epithelial edema impairing vision.

Do not induce vomiting. Never give anything by mouth to an unconscious person. Get medical attention.

Water spray (fog), foam, dry chemical or carbon dioxide.

Sealed containers at elevated temperatures or contaminated with water may rupture explosively. During a fire, MDI vapors and other irritating, highly toxic gases may be generated by thermal decomposition or combustion.

In case of fire, keep containers cool with water spray.

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel. Evacuate and ventilate spill area; dike spill to prevent entry into water system; wear full protective equipment during clean-up.

For minor spills, absorb isocyanates with sawdust or other absorbent, shovel into suitable unsealed containers, transport to well ventilated area (outside) and treat with neutralizing solution: mixture of 80% water and 20% non-ionic surfactant Tergitol TMN-10; or 90% water, 3-8% concentrated ammonia and 2% detergent. Add about ten parts of neutralizer per part of isocyanate, with mixing. Allow to stand uncovered for 48 hours to let carbon dioxide escape.

Large quantities may be pumped into closed, but not sealed containers for disposal.

Do not allow product to enter sewer or waterways.

Evacuate and ventilate spill area; dike spill to prevent entry into water system; wear full protective equipment during clean-up. If temporary control of isocyanate vapor is required, a blanket of protein foam (available at most fire departments) may be placed over spill. Large quantities may be pumped into closed, but not sealed containers for disposal. For minor spills, absorb isocyanates with sawdust or other absorbent, shovel into suitable unsealed containers, transport to well ventilated area (outside) and treat with neutralizing solution.

Materials: sawdust or other absorbent

Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. Exposure to vapors of heated MDI can be extremely dangerous. Protect from moisture. Keep away from heat, spark and flame.

Store at or below 30 °C (86°F). Store in tightly closed containers to prevent moisture contamination. Do not reseal if contamination is suspected. Store in a cool, dry place under low relative humidity, away from excessive heat.

Wash thoroughly after handling.

Keep away from heat, spark and flame.

Stable under normal conditions of storage and use.

Not available.

Rapid exothermic polymerization will occur in the presence of water, amines, alkalis and alcohols.

Keep away from heat, spark and flame. High temperatures. Contamination with water. Store away from incompatible materials.

Water. Amines. Strong bases. Alcohols. Copper alloys.

Thermal decomposition can lead to release of irritating gases and vapors. Hydrogen cyanide. MDI vapors and aerosols. Oxides of carbon. Oxides of nitrogen.