3M Finesse-It Finishing Material 09639

Remove person to fresh air. If you feel unwell, get medical attention.

Wash with soap and water. If signs/symptoms develop, get medical attention.

Flush with large amounts of water. Remove contact lenses if easy to do. Continue rinsing. If signs/symptoms persist, get medical attention.

Rinse mouth. If you feel unwell, get medical attention.

Use a fire fighting agent suitable for flammable liquids such as dry chemical or carbon dioxide to extinguish.

Water may not effectively extinguish fire.

Closed containers exposed to heat from fire may build pressure and explode.

Use water to keep fire-exposed containers and surfaces cool and prevent explosive rupture.

Evacuate area.

For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapours, in accordance with good industrial hygiene practice.

Avoid release to the environment.

Collect as much of the spilled material as possible using non-sparking tools. Place in a closed container approved for transportation by appropriate authorities. Clean up residue with water. Seal the container.

Avoid breathing of dust created by cutting, sanding, grinding or machining. For industrial/occupational use only. Not for consumer sale or use. Do not use in a confined area with minimal air exchange. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Avoid breathing dust/fume/gas/mist/vapours/spray. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Avoid release to the environment. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.) Vapours may travel long distances along the ground or floor to an ignition source and flash back.

Store in a well-ventilated place. Keep cool. Store away from heat.

Do not eat, drink or smoke when using this product. Wash thoroughly after handling.

Keep away from heat/sparks/open flames/hot surfaces. - No smoking.

Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.

Select and use gloves approved to relevant local standards to prevent skin contact based on the results of an exposure assessment. Nitrile gloves may be worn over polymer laminate gloves to improve dexterity. Gloves made from the following material(s) are recommended: Polymer laminate (Thickness >.3 mm, Breakthrough Time > 8 hours). Use gloves tested to EN 374

Safety glasses with side shields. Use eye protection conforming to EN 166

Half facepiece or full facepiece air-purifying respirator suitable for organic vapours and particulates. Use a respirator conforming to EN 140 or EN 136: filter types A & P

Select and use protective clothing approved to relevant local standards to prevent skin contact based on the results of an exposure assessment.

Refer to Annex

Stable.

This material may be reactive with certain agents under certain conditions - see the remaining headings in this section

Hazardous polymerisation will not occur.

Heat.

Strong acids. Strong oxidising agents.

Hydrocarbons, Carbon monoxide, Carbon dioxide.