NextSDS Logo
Safety Data Sheet EN

Eclipse Hard Floor Sealer

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
Eclipse Hard Floor Sealer
Product Code
403

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Floor sealer

Uses advised against

Other than per labelled instructions.

Manufacturers & Suppliers

Amano Pioneer Eclipse Corporation logo

Amano Pioneer Eclipse Corporation

manufacturer

P.O. Box 909, 1 Eclipse Road, Sparta, NC 28675

1-336-372-8080

http://www.pioneereclipse.com

Emergency Contacts

CHEMTREC

1-800-424-9300

Day or Night

CHEMTREC

1-703-527-3887

Day or Night

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified no signal word

Hazard Classifications

Not Classified

GHS Pictograms

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
propylene glycol monobutyl ether EC: 225-878-4 5131-66-8 1 - 5% Yes
(2-methoxymethylethoxy)-propanol EC: 252-104-2 34590-94-8 1 - 5% No
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

If breathing is difficult, remove to fresh air.

Symptoms: None expected under normal use.

Skin contact

Wash with plenty of water.

Symptoms: None expected under normal use.

Eye contact

Rinse with plenty of water.

Symptoms: None expected under normal use.

Ingestion

If ingested, do not induce vomiting.

Symptoms: None expected under normal use.

Immediate Medical Attention

If irritation develops, seek medical attention. If symptoms persist, seek medical attention. Seek medical attention.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Dry chemical, water spray, foam, carbon dioxide

Specific hazards

Materials can splatter above 100°C/212°F.

Instructions

No special firefighting procedures recommended.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Small spill

Absorb spill on inert material (e.g. sand, earth) and dispose of as waste material in accordance with national and regional provisions.

Large spill

Keep spectators away. Floors may be slippery; use care to avoid falling. Neutralize spill area. Dike and contain spill with inert material (e.g. sand, earth). Transfer liquid to containers for recovery or disposal and solid diking material to separate containers for disposal.

Environmental

Keep spills and cleaning runoff out of sewers and open bodies of water.

Cleanup methods

Absorb spill on inert material; Transfer liquid to containers for recovery or disposal and solid diking material to separate containers for disposal.

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Avoid contact with eyes and skin. Wash thoroughly after handling. Use in well-ventilated areas.

Storage

Keep from freezing. Keep container sealed when not in use. Keep out of reach of children.

Hygiene

Wash thoroughly after handling.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Use only with adequate ventilation. Use local ventilation and other engineering controls to maintain

Hands

Chemical resistant gloves are recommended.

Eyes

Safety eyewear is recommended, to avoid chemical splashes and mists.

Respiratory

Respiratory protection should be worn when there is a potential of inadequate ventilation. If exposure limits are exceeded or symptoms are experienced, use an approved respirator.

Skin/Body

If major exposure is possible, wear suitable protection such as rubber boots, apron, etc.

Environmental

No specific environmental exposure controls known.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State Data
liquid
Relative Density
1.02 kg/L @ 20°C
Melting Point
---
Vapor Density
N/E
Colour
---
Solubility In Fat
---
Solubility In Water
---
Partition Coefficient
N/E
Form
---
Crystallisation Point
---
Evaporation Rate
N/E
State Under Standard Conditions
---
Relative Evaporation Rate
---
Odor
slight odor, no added fragrance
Flash Point
> 93°C
Kinematic Viscosity
---
Solidification Point
---
Properties Status
---
Softening Point
---
Voc Content
7.02%
Flammability
---
Explosive Limits
---
Lower Explosive Limit
N/E
Appearance
thin, milky white, opaque liquid
Upper Explosive Limit
N/E
Density
---
Auto Ignition Temperature
N/E
Freezing Point
N/E
Metal Corrosion
---
Boiling Point
N/E
Physical State
liquid
Odor Threshold
N/E
Bulk Density
---
Cloud Point
---
Dynamic Viscosity
<10 centipoise @ 20°C
Solubility
miscible in water
Colour Intensity
---
Molecular Weight
---
Decomposition Temperature
N/E
Vapor Pressure
N/E
Ph
7.8
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal conditions.

Reactivity

None known

Hazardous reactions

None known

Avoid

None known

Incompatible

Strong acids, bases and oxidizing agents.

Decomposition

None known

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for Eclipse Hard Floor Sealer?

The signal word is no signal word.

What is the physical form of Eclipse Hard Floor Sealer?

Eclipse Hard Floor Sealer is a liquid appearing as thin, milky white, opaque liquid . It has slight odor, no added fragrance odor.

What is the solubility of Eclipse Hard Floor Sealer?

miscible in water

What is Eclipse Hard Floor Sealer used for?

Floor sealer