Tectyl® MULTIPURPOSE AMBER RUST PREVENTATIVE

Move to fresh air. If unconscious, place in recovery position and seek medical advice. Consult a physician after significant exposure.

Symptoms: drowsiness or dizziness

First aid is not normally required. However, it is recommended that exposed areas be cleaned by washing with soap and water.

Flush eyes with water as a precaution. Remove contact lenses. Protect unharmed eye. If eye irritation persists, consult a specialist.

Do not give milk or alcoholic beverages. Never give anything by mouth to an unconscious person. If symptoms persist, call a physician.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. Water spray, Foam, Alcohol-resistant foam, Carbon dioxide (CO2), Dry chemical

High volume water jet

Never use welding or cutting torch on or near drum (even empty) because product (even just residue) can ignite explosively. Beware of vapours accumulating to form explosive concentrations. Vapours can accumulate in low areas.

Use a water spray to cool fully closed containers.

Evacuate personnel to safe areas. Remove all sources of ignition. Ensure adequate ventilation. Beware of vapours accumulating to form explosive concentrations. Vapours can accumulate in low areas. Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed.

Prevent product from entering drains. Prevent further leakage or spillage if safe to do so.

Open drum carefully as content may be under pressure. Do not breathe vapours/dust. Do not smoke. Container hazardous when empty. Avoid exposure - obtain special instructions before use. For personal protection see section 8.

Keep container tightly closed in a dry and well-ventilated place. Containers which are opened must be carefully resealed and kept upright to prevent leakage. Keep away from direct sun exposure and temperatures over 50 °C.

Wash hands before breaks and at the end of workday. Smoking, eating and drinking should be prohibited in the application area.

Take necessary action to avoid static electricity discharge (which might cause ignition of organic vapours). Keep away from open flames, hot surfaces and sources of ignition.

Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below exposure guidelines (if applicable) or below levels that cause known, suspected or apparent adverse effects.

Material: nitrile rubber; Break through time: 480 min; Glove thickness: 0,38 mm; Remarks: The selected protective gloves have to satisfy the specifications of Regulation (EU) 2016/425 and the standard EN 374 derived from it. The suitability for a specific workplace should be discussed with the producers of the protective gloves.

Not required under normal conditions of use. Wear splash-proof safety goggles if material could be misted or splashed into eyes.

In the case of vapour formation use a respirator with an approved filter. In the case of dust or aerosol formation use respirator with an approved filter. Filter type: Combined particulates, organic gas and low boiling vapour type (AX-P)

Wear as appropriate: Impervious clothing, Safety shoes, Flame-resistant clothing. Choose body protection according to the amount and concentration of the dangerous substance at the work place.

Stable under recommended storage conditions.

No decomposition if stored and applied as directed.

Vapours may form explosive mixture with air.

Heat, flames and sparks. excessive heat. Do not allow evaporation to dryness. Exposure to air.

Acids, Oxidizing agents, salts of strong bases, strong bases

No hazardous decomposition products are known.