ADDITIN RC 8210

If unconscious, place in recovery position and seek medical advice. Get medical attention if symptoms appear.

If on skin, rinse well with water. If on clothes, remove clothes. Get medical attention if symptoms appear.

Flush eyes with water as a precaution. Remove contact lenses. Keep eye wide open while rinsing. Get medical attention if symptoms appear.

Keep respiratory tract clear. Do not give milk or alcoholic beverages. Never give anything by mouth to an unconscious person. Get medical attention if symptoms appear.

Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.

High volume water jet

Do not allow run-off from fire fighting to enter drains or water courses.

Standard procedure for chemical fires. Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire.

Use personal protective equipment. Keep unnecessary and unprotected personnel from entering. Do not touch or walk through spilt material. Evacuate personnel to safe areas.

Prevent product from entering drains. Prevent further leakage or spillage if safe to do so.

Wipe up with absorbent material (e.g. cloth, fleece). Move containers from spill area.

Materials: cloth, fleece

Avoid contact with skin and eyes. For personal protection see section 8. Smoking, eating and drinking should be prohibited in the application area. Dispose of rinse water in accordance with local and national regulations.

Store in original container protected from direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials (see Section 10) and food and drink. Keep away from heat and sources of ignition. Containers which are opened must be carefully resealed and kept upright to prevent leakage. Electrical installations / working materials must comply with the technological safety standards. Do not store in unlabelled containers. Observe label precautions. Keep containers sealed until ready for use.

When using do not eat or drink. When using do not smoke. Wash hands before breaks and at the end of workday.

Normal measures for preventive fire protection.

Good general ventilation should be sufficient to control worker exposure to airborne contaminants.

Material : Natural Rubber Glove thickness : 0,4 mm Remarks : Breakthrough time is not determined for the product. Change gloves often! After contamination with product change the gloves immediately and dispose of them according to relevant national and local regulations. The suitability for a specific workplace should be discussed with the producers of the protective gloves. Material : Protective gloves complying with EN 374.

Safety glasses with side-shields Equipment should conform to EN 166

In the case of vapour formation use a respirator with an approved filter. Respirator selection must be based on known or anticipated exposure levels, the hazards of the product and the safe working limits of the selected respirator. Filter type : ABEK-filter

Wear suitable protective clothing. Long sleeved clothing Choose body protection according to the amount and concentration of the dangerous substance at the work place.

The product is chemically stable.

No specific test data related to reactivity available for this product or its ingredients.

Under normal conditions of storage and use, hazardous reactions will not occur.

Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.

Oxidizing agents

No hazardous decomposition products are known.

Send to a licensed waste management company.

The generation of waste should be avoided or minimised wherever possible.

Not dangerous cargo. Keep separated from foodstuffs.

Not dangerous cargo. Keep separated from foodstuffs.

Not dangerous cargo. Keep separated from foodstuffs.