Synfluid® PAO 8 cSt

If unconscious, place in recovery position and seek medical advice. If symptoms persist, call a physician.

Remove contact lenses. Protect unharmed eye. If eye irritation persists, consult a specialist.

Keep respiratory tract clear. Never give anything by mouth to an unconscious person. If symptoms persist, call a physician.

Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.

High volume water jet.

Standard procedure for chemical fires.

Standard procedure for chemical fires.

Use personal protective equipment. Ensure adequate ventilation. Evacuate personnel to safe areas. Material can create slippery conditions.

No special environmental precautions required.

Wipe up with absorbent material (e.g. cloth, fleece).

Materials: cloth, fleece

For personal protection see section 8. Smoking, eating and drinking should be prohibited in the application area.

Electrical installations / working materials must comply with the technological safety standards.

Smoking, eating and drinking should be prohibited in the application area.

Normal measures for preventive fire protection.

Adequate ventilation to control airborne concentrations below the exposure guidelines/limits. Consider the potential hazards of this material (see Section 2), applicable exposure limits, job activities, and other substances in the work place when designing engineering controls and selecting personal protective equipment. If engineering controls or work practices are not adequate to prevent exposure to harmful levels of this material, the personal protective equipment listed below is recommended. The user should read and understand all instructions and limitations supplied with the equipment since protection is usually provided for a limited time or under certain circumstances.

The suitability for a specific workplace should be discussed with the producers of the protective gloves. Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion, and the contact time. Gloves should be discarded and replaced if there is any indication of degradation or chemical breakthrough.

Eye wash bottle with pure water. Tightly fitting safety goggles.

If ventilation or other engineering controls are not adequate to maintain minimal oxygen content of 19.5% by volume under normal atmospheric pressure, a supplied-air NIOSH approved respirator may be appropriate.

Choose body protection according to the amount and concentration of the substance and the task performed at the work place. Appropriate PPE may include: Lightweight protective clothing.

A quantitative risk assessment is not required for the environment.

This material is considered stable under normal ambient and anticipated storage and handling conditions of temperature and pressure.

Stable at normal ambient temperature and pressure.

No hazards to be specially mentioned.

No data available.

No data available.

No data available.

Use material for its intended purpose or recycle if possible.

This material, if it must be discarded, may meet the criteria of a hazardous waste as defined by US EPA under RCRA (40 CFR 261) or other State and local regulations. Measurement of certain physical properties and analysis for regulated components may be necessary to make a correct determination. If this material is classified as a hazardous waste, federal law requires disposal at a licensed hazardous waste disposal facility.