FM HEAT TRANSFER FLUID 32

Supply fresh air; consult doctor in case of complaints.

Immediately wash with water and soap and rinse thoroughly. If skin irritation continues, consult a doctor.

Check for and remove any contact lenses. Rinse opened eye for several minutes under running water.

Wash mouth out with water. Seek medical treatment.

CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam. Use fire extinguishing methods suitable to surrounding conditions.

Water with full jet

Formation of toxic gases is possible during heating or in case of fire.

Particular danger of slipping on leaked/spilled product.

Do not allow to penetrate the ground/soil. Prevent from spreading (e.g. by damming-in or oil barriers). Do not allow to enter sewers/ surface or ground water.

Absorb with liquid-binding material. Send for recovery or disposal in suitable receptacles.

Materials: sand, diatomite, acid binders, universal binders, sawdust

Ensure good ventilation/exhaustion at the workplace. Use only if manufacturer's seal is intact.

Store in cool, dry conditions in well sealed receptacles.

No special measures required.

No further data; see item 7.

Protective gloves (EN374). The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed. For the permanent contact gloves made of the following materials are suitable: Nitrile rubber, NBR, Neoprene gloves. Not suitable are gloves made of the following materials: Butyl rubber, BR, Natural rubber, NR.

Safety glasses

Respiratory protection will be necessary only in special cases (e.g. formation of mists). A half or full face respirator with combined dust/organic vapour filter(s), or a Self-Contained Breathing Apparatus (SCBA) can be used according to the extent of spill and predictable amount of exposure. If the situation cannot be completely assessed, or if an oxygen deficiency is possible, only SCBA’s should be used.

Protective work clothing

No dangerous reactions known.

Naked flames, hot surfaces and other high temperature sources

Strong oxidising agents.

Possible in traces. No decomposition if used and stored according to specifications.

Contact waste processors for recycling information. Delivery of waste oil to officially authorized collectors only.

Must not be disposed together with household garbage. Do not allow product to reach sewage system.