FSNK EMMENTAL K205753000

Move to fresh air. Call a physician if symptoms develop or persist.

Wash off with soap and water. Get medical attention if irritation develops and persists.

Do not rub eyes. Rinse with water. Get medical attention if irritation develops and persists.

Rinse mouth. Get medical attention if symptoms occur.

Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2). Apply extinguishing media carefully to avoid creating airborne dust. Avoid high pressure media which could cause the formation of a potentially explosive dust-air mixture.

Do not use water jet as an extinguisher, as this will spread the fire.

May form explosive dust-air mixture if dispersed. Explosion hazard: Avoid generating dust; fine dust dispersed in air in sufficient concentrations and in the presence of an ignition source is a potential dust explosion hazard. During fire, gases hazardous to health may be formed.

In case of fire and/or explosion do not breathe fumes. Move containers from fire area if you can do so without risk. Use standard firefighting procedures and consider the hazards of other involved materials.

Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Stop the flow of material, if this is without risk.

Sweep up or vacuum up spillage and collect in suitable container for disposal.

Wet down with water and dike for later disposal. Shovel the material into waste container. Following product recovery, flush area with water.

Avoid discharge into drains, water courses or onto the ground.

Collect dust using a vacuum cleaner equipped with HEPA filter. Sweep up or vacuum up spillage.

Minimise dust generation and accumulation. Avoid significant deposits of material, especially on horizontal surfaces, which may become airborne and form combustible dust clouds and may contribute to secondary explosions. Routine housekeeping should be instituted to ensure that dusts do not accumulate on surfaces. Dry powders can build static electricity charges when subjected to the friction of transfer and mixing operations. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Wear appropriate personal protective equipment. Observe good industrial hygiene practices.

Keep containers tightly closed in a dry, cool and well-ventilated place.

Observe good industrial hygiene practices.

Keep away from heat/sparks/open flames/hot surfaces. - No smoking.

Explosion-proof general and local exhaust ventilation. Good general ventilation should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. If engineering measures are not sufficient to maintain concentrations of dust particulates below the OEL (occupational exposure limit), suitable respiratory protection must be worn.

Wear appropriate chemical resistant gloves.

Wear safety glasses with side shields (or goggles).

Wear a dust mask if dust is generated above exposure limits.

Wear suitable protective clothing.

Emissions from ventilation or work process equipment should be checked to ensure they comply with the requirements of environmental protection legislation. Fume scrubbers, filters or engineering modifications to the process equipment may be necessary to reduce emissions to acceptable levels.

Material is stable under normal conditions.

The product is stable and non-reactive under normal conditions of use, storage and transport.

No dangerous reaction known under conditions of normal use.

Keep away from heat, sparks and open flame. Contact with incompatible materials. Minimise dust generation and accumulation.

Strong oxidising agents.

No hazardous decomposition products are known.

Dispose of in accordance with local regulations. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe manner.

Collect and reclaim or dispose in sealed containers at licensed waste disposal site. Dispose of contents/container in accordance with local/regional/national/international regulations.