TB-25 WELD CLEANING FLUID FOR STAINLESS STEEL (AU)

If inhaled, remove from contaminated area. Apply artificial respiration if not breathing.

If skin or hair contact occurs, wash with soap and water and see doctor if irritation persists. For chronic exposure remove clothes, have a shower and call a doctor.

If in eyes, hold eyelids apart and flush continuously with running water. Continue flushing until advised to stop by a Poisons Information Centre, a doctor, or for at least 15 minutes.

For advice, contact a Poison Information Centre on 13 11 26 (Australia Wide) or a doctor (at once). If swallowed, do not induce vomiting.

Use an extinguishing agent suitable for the surrounding fire.

Non flammable. May evolve toxic gases (phosphorus oxides) when heated to decomposition. Contact with most metals may evolve flammable hydrogen gas.

Treat as per requirements for surrounding fires. Use waterfog to cool intact containers and nearby storage areas.

Wear Personal Protective Equipment (PPE) as detailed in section 8 of the SDS. Clear area of all unprotected personnel. Ventilate area where possible. Contact emergency services where appropriate.

Prevent product from entering drains and waterways.

Collect for complete neutralisation and appropriate disposal.

Materials: sodium bicarbonate or 50-50 mixture of sodium carbonate and calcium hydroxide

Before use carefully read the product label. Use of safe work practices are recommended to avoid eye or skin contact and inhalation. This solution should not be used in a spraying application.

Store in a cool, dry, well ventilated area, removed from incompatible substances, heat or ignition sources and foodstuffs. Ensure containers are adequately labelled, protected from physical damage and sealed when not in use.

Observe good personal hygiene, including washing hands before eating. Prohibit eating, drinking and smoking in contaminated areas.

removed from heat or ignition sources

Avoid inhalation. Use in well ventilated areas. Where an inhalation risk exists, mechanical extraction ventilation is recommended.

Wear full-length PVC or full-length rubber or full-length butyl or full-length neoprene or full-length viton (R) or full-length nitrile gloves.

Wear splash-proof goggles. When using large quantities or where heavy contamination is likely, wear full face protection.

Where an inhalation risk exists, wear a Type B (Inorganic gases and vapours) respirator. If spraying, with prolonged use, or if in confined areas, wear an Air-line respirator.

Wear good quality (cotton drill etc) work wear and use common sense and section 4 First aid measures if required. If using large quantities for long periods, or if working at eye level or overhead, coveralls, rubber boots and PVC apron should be used.

Stable under recommended conditions of storage.

May be corrosive to metals.

Polymerization is not expected to occur.

Avoid heat, sparks, open flames and other ignition sources.

oxidising agents (e.g. hypochlorites), alkalis (e.g. sodium hydroxide) and metals.

May evolve toxic gases (phosphorus oxides) when heated to decomposition.

F-A, S-B