NextSDS Logo
Safety Data Sheet EN

diff colors

How compliant is your chemical safety?

Free 2-minute compliance assessment

Check Now
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
diff colors
Product Code
REZ1062

Regulatory Identifiers

CAS Number
N/A

Identified Uses

SU21 Consumer uses: Private households / general public / consumers SU3 Industrial uses: Uses of substances as such or in preparations at industrial sites SU22 Professional uses: Public domain (administration, education, entertainment, services, craftsmen) painting

Uses advised against

No further relevant information available.

Manufacturers & Suppliers

P

Peter Kwasny GmbH

manufacturer

Heilbronner Str. 96 D-74831 Gundelsheim

0049-(0)6269-95-20

Emergency Contacts

Emergency Contact

+49 6269 95 20

National Poisons Information Service, Birmingham

844 892 0111

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Aerosol Cat. 1 H222
Eye Irrit. Cat. 2 H319
STOT SE Cat. 3 H336

GHS Pictograms

GHS02 - Flammable

GHS02

GHS07 - Health hazard

GHS07

Hazard Statements

H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.

Precautionary Statements

P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P103 Read carefully and follow all instructions.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P271 Use only outdoors or in a well-ventilated area.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P312 Call a POISON CENTER/doctor if you feel unwell.
P337 + P313 If eye irritation persists: Get medical advice/attention.
P410 + P412 Protect from sunlight. Do not expose to temperatures exceeding 50 C/122 F.
P501 Dispose of contents/container in accordance with local/regional/national/international regulations.

Manage your Safety Data Sheets

Organize and access chemical safety data with ease

Manage SDS
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

Mixture of substances listed below with nonhazardous additions.

Chemical Name CAS Number Concentration Hazardous
N/A --- 25 - 50% Yes
N/A --- 10 - 25% Yes
N/A --- 5 - 10% Yes
N/A --- 5 - 10% Yes
N/A --- 5 - 10% Yes
N/A --- 5 - 10% Yes
N/A --- 2.5 - 5% Yes
N/A --- 2.5 - 5% Yes
N/A --- 1 - 2.5% Yes
N/A --- 1% Yes
N/A --- 1% Yes
N/A --- 1% Yes
N/A --- 0.025 - 0.25% Yes

For the wording of the listed hazard phrases refer to section 16.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Supply fresh air; consult doctor in case of complaints.

Eye contact

Rinse opened eye for several minutes under running water.

Related Substances

Similar chemicals with comparable safety profiles

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

No further data; see section 7.

Hands

Protective gloves The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation Gloves must be changed after every contamination. The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be observed. For the permanent contact of a maximum of 15 minutes gloves made of the following materials are suitable: butyl rubber, 0,7mm

Eyes

Safety glasses Tightly sealed goggles

Respiratory

When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. Half mask with combination filter, class A1P2 minimum, or breathing mask with outer air supply.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Vapor Pressure
3,600 hPa at 20 C (74-98-6 propane); 800 hPa at 50 C
Cloud Point
---
Odor Threshold
Not determined.
Decomposition Temperature
Not determined.
Solubility In Fat
---
Metal Corrosion
Void
Lower Explosive Limit
1.7 Vol % (74-98-6 propane)
Density
---
Crystallisation Point
---
Ph
Not determined.
Molecular Weight
---
Melting Point
Undetermined.
Freezing Point
Undetermined.
Solubility In Water
Not miscible or difficult to mix.
Bulk Density
---
Appearance
---
Flash Point
<0 C
Kinematic Viscosity
Not determined.
Relative Density
0.833 g/cm
Solidification Point
---
Auto Ignition Temperature
315 C (108-65-6 2-methoxy-1-methylethyl acetate)
Colour Intensity
---
Evaporation Rate
Not applicable.
Odor
Characteristic
Solubility
---
Physical State Data
aerosol
Partition Coefficient
Not determined.
Form
Aerosol
State Under Standard Conditions
---
Physical State
Aerosol
Vapor Density
Not determined.
Flammability
Not applicable.
Colour
According to product specification
Dynamic Viscosity
Not determined.
Upper Explosive Limit
13 Vol % (67-64-1 acetone)
Explosive Limits
---
Softening Point
---
Relative Evaporation Rate
---
Voc Content
85.88 %
Boiling Point
-44 C
Properties Status
---
14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
UN1950
Packing Group
Void
?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for diff colors?

The signal word is danger.

What is the physical form of diff colors?

diff colors is a aerosol with according to product specification color. It has characteristic odor.

What is diff colors used for?

SU21 Consumer uses: Private households / general public / consumers SU3 Industrial uses: Uses of substances as such or in preparations at industrial sites SU22 Professional uses: Public domain (administration, education, entertainment, services, craftsmen) painting

What are the hazard statements for diff colors?

This substance has 4 hazard statements:

  • H222: Extremely flammable aerosol.
  • H229: Pressurised container: May burst if heated.
  • H319: Causes serious eye irritation.
  • H336: May cause drowsiness or dizziness.

What is the melting point of diff colors?

The melting point is Undetermined. and the boiling point is -44 C.

Compliance Scan

Free compliance check