Chemical Product Identification & Regulatory Data
Official chemical identifiers, CAS numbers, and regulatory compliance information
Basic Product Information
Regulatory Identifiers
Chemical Abstracts Service registry number - unique identifier for chemical substances
Uses Information
Overview
3M Photomount (PL 9479) commonly used adhesive aerosol..
Manage Your Safety Data Sheets
Organize and access your chemical safety data with ease.
GHS Hazard Classification & Safety Warnings
Globally Harmonized System (GHS) hazard pictograms, signal words, and safety classifications
Classification Status
Signal Word
Hazard Classifications
GHS Hazard Pictograms & Safety Symbols
GHS02
GHS07
GHS09
GHS (Globally Harmonized System) pictograms indicate specific chemical hazard categories and safety precautions
Hazard Statements
- H222: Extremely flammable aerosol.
- H229: Pressurised container: may burst if heated.
- H315: Causes skin irritation.
- H319: Causes serious eye irritation.
- H317: May cause an allergic skin reaction.
- H336: May cause drowsiness or dizziness.
- H411: Toxic to aquatic life with long lasting effects.
Precautionary Statements
- P102: Keep out of reach of children.
- P210: Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
- P211: Do not spray on an open flame or other ignition source.
- P251: Do not pierce or burn, even after use.
- Wear protective gloves.
- Protect from sunlight. Do not expose to temperatures exceeding 50/122F.
- P501: Dispose of contents/container in accordance with applicable local/regional/national/international regulations.
Chemical Manufacturers & Supply Chain
Authorized suppliers, manufacturers, and distribution network information
3M Ireland Limited
undefined
24/7 Emergency Response & Poison Control
Critical emergency contact numbers for chemical spills, exposure incidents, and medical emergencies
National Poisons Information Centre
+353 (0)1 809 2166
IE
8am-10pm (seven days)
Beaumont Hospital, Dublin 9 DOV2NO, Ireland.
Chemical Composition & Hazardous Ingredients
Detailed component analysis, concentration ranges, and hazardous substance identification
Product Type
mixtureChemical Components & Hazardous Substances
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| acetone EC: 200-662-2 | 67-64-1 | 15-40% | ⚠️ Hazardous |
| propane EC: 200-827-9 | 74-98-6 | 25-35% | ⚠️ Hazardous |
| Non-volatiles | N/A | 10-30% | ✓ Non-hazardous |
| cyclohexane EC: 203-806-2 | 110-82-7 | 10-30% | ⚠️ Hazardous |
| Rosin and resin acids, esters with glycerol | 65997-10-6 | 1-5% | ⚠️ Hazardous |
| Non-Hazardous Ingredients EC: 231-791-2 | 7732-18-5 | 3% | ✓ Non-hazardous |
| Resin acids and Rosin acids, esters with diethylene glycol EC: 268-884-2 | 68153-38-8 | 3% | ✓ Non-hazardous |
Emergency First Aid Measures
Critical first aid procedures for chemical exposure incidents and medical emergencies
🫁 Inhalation Exposure
Remove person to fresh air. Get medical attention.
🖐️ Skin Contact
Immediately wash with soap and water. Remove contaminated clothing and wash before reuse. If signs/symptoms develop, get medical attention.
Symptoms:
Irritation to the skin (localized redness, swelling, itching, and dryness). Allergic skin reaction (redness, swelling, blistering, and itching).
👁️ Eye Contact
Immediately flush with large amounts of water. Remove contact lenses if easy to do. Continue rinsing. Get medical attention.
Symptoms:
Serious irritation to the eyes (significant redness, swelling, pain, tearing, and impaired vision).
🍽️ Ingestion/Swallowing
Rinse mouth. If you feel unwell, get medical attention.
Symptoms:
Central nervous system depression (headache, dizziness, drowsiness, incoordination, nausea, slurred speech, giddiness, and unconsciousness).
Medical Treatment
Exposure may increase myocardial irritability.
Related Chemical Substances & Alternative Products
Similar chemicals with comparable safety profiles and industrial applications
Technical Specifications & Material Properties
Physical state, chemical properties, melting point, boiling point, and material characteristics
Exposure Controls & Personal Protective Equipment (PPE)
Occupational exposure limits, engineering controls, and required safety equipment
🏭 Engineering Controls
Do not remain in area where available oxygen may be reduced. Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
🧤 Hand Protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions. Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective clothing. Note: Nitrile gloves may be worn over polymer laminate gloves to improve dexterity. Gloves made from the following material(s) are recommended: Polymer laminate. Applicable Norms/Standards: Use gloves tested to EN 374.
👁️ Eye Protection
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face protection(s) are recommended: Full face shield. Indirect vented goggles. Applicable Norms/Standards: Use eye/face protection conforming to EN 166.
😷 Respiratory Protection
An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator type(s) to reduce inhalation exposure: Half facepiece or full facepiece air-purifying respirator suitable for organic vapours and particulates. Half facepiece or full facepiece supplied-air respirator. For questions about suitability for a specific application, consult with your respirator manufacturer. Applicable Norms/Standards: Use a respirator conforming to EN 140 or EN 136. Use a respirator conforming to EN 140 or EN 136: filter types A & P.
🦺 Skin/Body Protection
If this product is used in a manner that presents a higher potential for exposure (eg. spraying, high splash potential etc.), then use of protective coveralls may be necessary. Select and use body protection to prevent contact based on the results of an exposure assessment. The following protective clothing material(s) are recommended: Apron - polymer laminate.
🌍 Environmental Exposure Controls
Refer to Annex
Transportation & Shipping Information
UN numbers, shipping names, transport classes, and regulatory transport requirements
🏷️ UN Number
UN1950
📋 Packing Group
Not applicable.
🚛 ADR Transport Precautions
Please refer to the other sections of the SDS for further information.
🚢 IMDG Maritime Transport Precautions
Please refer to the other sections of the SDS for further information.
✈️ IATA Air Transport Precautions
Please refer to the other sections of the SDS for further information.
Chemical Safety FAQ & Common Questions
Most frequently asked questions about safety, handling, storage, and regulatory compliance
What is the hazard signal word for 3M Photomount (PL 9479)?
The signal word for this substance is "danger".
What is the physical form of 3M Photomount (PL 9479)?
3M Photomount (PL 9479) is a liquid. with colourless color. It has mild solvent odor.
What is the solubility of 3M Photomount (PL 9479)?
No data available.
What is 3M Photomount (PL 9479) used for?
Adhesive aerosol.
What are the hazard statements for 3M Photomount (PL 9479)?
This substance has 7 hazard statements: H222: Extremely flammable aerosol. H229: Pressurised container: may burst if heated. H315: Causes skin irritation. H319: Causes serious eye irritation. H317: May cause an allergic skin reaction. H336: May cause drowsiness or dizziness. H411: Toxic to aquatic life with long lasting effects.
What is the melting point of 3M Photomount (PL 9479)?
The melting point is Not applicable. and the boiling point is Not applicable..