Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- Memosil 2
Regulatory Identifiers
- CAS Number
- N/A
Identified Uses
Dental impression material
Manufacturers & Suppliers
Kulzer GmbH
manufacturer
Leipziger Strae 2, 63450 Hanau (Germany)
+49 (0)800 4372522
Emergency Contacts
Emergency Contact
+49 (0)6132-84463
24-Hour-Number
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
GHS Pictograms
Manage your Safety Data Sheets
Organize and access chemical safety data with ease
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
2-component silicone impression material comprising base paste and matching catalyst paste for addition curing
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| Octamethyl Cyclotetrasiloxane EC: 209-136-7 | 556-67-2 | 3% | Yes |
First Aid Measures
Emergency procedures for chemical exposure incidents
Supply fresh air; consult doctor in case of symptoms.
Instantly wash with water and soap and rinse thoroughly.
Rinse opened eye for several minutes under running water.
Rinse out mouth and then drink plenty of water. In case of persistent symptoms consult doctor.
Immediate Medical Attention
No further relevant information available.
Medical Treatment
No further relevant information available.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
The data for this section has not been processed yet.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
The data for this section has not been processed yet.
Related Products
Similar products with comparable safety profiles
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
The data for this section has not been processed yet.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Check protective gloves prior to each use for their proper condition. Recommended. The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be observed. For the permanent contact of a maximum of 15 minutes gloves made of the following materials are suitable: Butyl rubber, BR; Nitrile rubber, NBR.
Not absolutely necessary.
Not required.
Light weight protective clothing
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
The data for this section has not been processed yet.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
The data for this section has not been processed yet.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
Regulatory Information
Chemical regulations, safety assessments, and compliance status
The data for this section has not been processed yet.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for Memosil 2?
The signal word is no signal word.
What is Memosil 2 used for?
Dental impression material
What is the melting point of Memosil 2?
The melting point is Not determined and the boiling point is Not determined.