NextSDS Logo
Safety Data Sheet EN

BONDERITE C-AK L-95 known as Novaclean L 95

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
BONDERITE C-AK L-95 known as Novaclean L 95
Product Code
1917277

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Cleaners for industrial metal working

Uses advised against

None identified

Manufacturers & Suppliers

Henkel Corporation logo

Henkel Corporation

manufacturer

One Henkel Way, Rocky Hill, Connecticut 06067

+1 (860) 571-5100

www.henkelna.com

Emergency Contacts

Poison Control Center

1-877-671-4608

Poison Control Center

1-303-592-1711

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

CORROSIVE TO METALS Cat. 1
SKIN CORROSION Cat. 1
SERIOUS EYE DAMAGE Cat. 1
CARCINOGENICITY Cat. 2
SPECIFIC TARGET ORGAN TOXICITY - REPEATED EXPOSURE Cat. 2

GHS Pictograms

GHS05 - Corrosive

GHS05

GHS08 - Serious health hazard

GHS08

Hazard Statements

H290 MAY BE CORROSIVE TO METALS.
H314 CAUSES SEVERE SKIN BURNS AND EYE DAMAGE.
H351 SUSPECTED OF CAUSING CANCER.
H372 MAY CAUSE DAMAGE TO ORGANS THROUGH PROLONGED OR REPEATED EXPOSURE.

Precautionary Statements

P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P234 Keep only in original packaging.
P261 Do not breathe vapors, mist, or spray.
P264 Wash affected area thoroughly after handling.
P280 Wear protective gloves, clothing, eye and face protection.
P301 + P330 + P331 IF SWALLOWED: Rinse mouth.
P304 + P341 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing.
P308 + P313 IF exposed or concerned: Get medical attention.
P310 Immediately call a POISON CENTER or physician.
P331 Do NOT induce vomiting.
P338 Remove contact lenses, if present and easy to do. Continue rinsing.
P351 IF IN EYES: Rinse cautiously with water for several minutes.
P361 If on skin (or hair): Take off immediately all contaminated clothing.
P363 Wash contaminated clothing before reuse.
P390 Absorb spillage to prevent material damage.
P405 Store locked up.
P406 Store in corrosive resistant container with a resistant inner liner.
P501 Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Notes

Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Immediately remove victim to fresh air.

Skin contact

Immediately rinse with copious amounts of running water (for 10 minutes). Remove contaminated clothes. Put on a bandage with sterile gauze.

Eye contact

Immediately flush eyes with soft jet of water or eye rinse solution for at least 15 minutes. Hold eyelid wide-open. Eye flushing should continue during transportation to a doctor.

Ingestion

Rinse out mouth, drink 1-2 glasses of water, do not induce vomiting.

Immediate Medical Attention

Get immediate medical attention (Inhalation). Seek medical attention in hospital (Skin contact). Seek a doctor/hospital (Eye contact). Immediate medical treatment necessary (Ingestion).

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Carbon dioxide, foam, powder

Specific hazards

Formation of toxic gases is possible during heating or in fires.

Instructions

In case of fire, keep containers cool with water spray.

Firefighter Protection

Wear protective equipment.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel.

Environmental

Do not empty into drains / surface water / ground water.

Cleanup methods

Remove with liquid-absorbing material (sand, peat, sawdust).

Materials: liquid-absorbing material (sand, peat, sawdust)

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Ensure that workrooms are adequately ventilated. Avoid skin and eye contact. When diluting, always stir slowly the product into standing water. See advice in section 8

Storage

Ensure adequate ventilation. Store in sealed original container. Store in a dry place.

Hygiene

Avoid skin and eye contact.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State
clear to slightly cloudy, liquid
Physical State Data
liquid
State Under Standard Conditions
---
Appearance
---
Colour
colourless, up to, yellow
Colour Intensity
---
Form
---
Odor
characteristic
Odor Threshold
Not available.
Ph
> 13
Melting Point
Not applicable, Product is a liquid
Boiling Point
> 100 °C (> 212°F) Aqueous solution
Flash Point
Not applicable
Freezing Point
---
Softening Point
---
Solidification Point
---
Cloud Point
---
Crystallisation Point
---
Relative Evaporation Rate
---
Evaporation Rate
Not available.
Vapor Pressure
23.4 hPa (20 °C (68°F)) (aqueous solution)
Vapor Density
< 1 20 °C
Relative Density
---
Bulk Density
---
Density
---
Flammability
Not applicable
Upper Explosive Limit
Not available.
Lower Explosive Limit
Not available.
Explosive Limits
---
Auto Ignition Temperature
Not available.
Decomposition Temperature
Not available.
Solubility
---
Partition Coefficient
Not available.
Solubility In Water
Miscible Aqueous solution
Solubility In Fat
---
Molecular Weight
---
Voc Content
Not available.
Metal Corrosion
---
Dynamic Viscosity
10 mPa.s
Kinematic Viscosity
---
Properties Status
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal conditions of storage and use.

Reactivity

Not available.

Hazardous reactions

None under normal processing.

Avoid

None if used for intended purpose. Stable under recommended storage conditions.

Incompatible

Reacts with acids: Heat released. Reacts with water: generation of heat.

Decomposition

None if used for intended purpose. In case of fire toxic gases can be released.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
1719
Shipping Name
Caustic alkali liquids, n.o.s. (Sodium hydroxide, Potassium hydroxide)
Transport Class
8
Packing Group
II
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for BONDERITE C-AK L-95 known as Novaclean L 95?

The signal word is danger.

What is the physical form of BONDERITE C-AK L-95 known as Novaclean L 95?

BONDERITE C-AK L-95 known as Novaclean L 95 is a clear to slightly cloudy, liquid with colourless, up to, yellow color. It has characteristic odor.

What is BONDERITE C-AK L-95 known as Novaclean L 95 used for?

Cleaners for industrial metal working

What are the hazard statements for BONDERITE C-AK L-95 known as Novaclean L 95?

This substance has 4 hazard statements:

  • H290: MAY BE CORROSIVE TO METALS.
  • H314: CAUSES SEVERE SKIN BURNS AND EYE DAMAGE.
  • H351: SUSPECTED OF CAUSING CANCER.
  • H372: MAY CAUSE DAMAGE TO ORGANS THROUGH PROLONGED OR REPEATED EXPOSURE.

What is the melting point of BONDERITE C-AK L-95 known as Novaclean L 95?

The melting point is Not applicable, Product is a liquid and the boiling point is > 100 °C (> 212°F) Aqueous solution.