Genesol 80

Supply fresh air; consult doctor in case of complaints.

Immediately wash with water and soap and rinse thoroughly. If skin irritation continues, consult a doctor.

DO NOT DELAY! Check for and remove any contact lenses. Rinse opened eye for several minutes under running water. Then consult a doctor.

DO NOT DELAY! Rinse out mouth and then drink plenty of water. Do not induce vomiting; call for medical help immediately. If vomiting occurs spontaneously, keep head below hips to prevent aspiration.

Use fire extinguishing methods suitable to surrounding conditions.

During heating or in case of fire poisonous gases are produced.

Ensure adequate ventilation. Wear protective equipment. Keep unprotected persons away.

Do not allow to penetrate the ground/soil. Do not allow product to reach sewage system or any water course in the undiluted form.

Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust). Send for recovery or disposal in suitable receptacles.

Materials: sand, diatomite, acid binders, universal binders, sawdust

Keep away from heat and direct sunlight. Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols. Do not mix with acids. Avoid direct contact (skin/eye contact, ingestion and/or inhalation of fume/mist/dust) with the product in the undiluted form. Safety showers and eye wash facilities should be available at the work area. Contact lenses should not be worn while working with this product.

Store in cool, dry conditions in well sealed receptacles. Protect from frost. Keep container tightly sealed. Protect from heat and direct sunlight.

Safety showers and eye wash facilities should be available at the work area. Contact lenses should not be worn while working with this product.

No special measures required.

Additional information about design of technical facilities: No further data; see item 7.

The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.

Tightly sealed goggles with a cross through

Not necessary if room is well-ventilated. Use suitable respiratory protective device in case of insufficient ventilation.

Protective work clothing. Body protection must be chosen depending on product properties, activity and possible exposure.

No decomposition if used and stored according to specifications.

No further relevant information available.

No dangerous reactions known. Chlorine gas will be produced if mixed with acids.

No further relevant information available.

Strong acids and oxidising agents, Finely powdered metals., Ammonia

Carbon monoxide and carbon dioxide, Chlorine, Hydrogen chloride (HCl), Sulphur oxides (SOx), Metal oxide

Minimise waste; Reuse if not contaminated; Recycle, if possible; or Safe disposal (if all else fails). Contact waste processors for recycling information.

Must not be disposed together with household garbage. Do not allow product to reach sewage system. Used, degraded or contaminated product may be classified as hazardous waste.