NAPHTHA (PETROLEUM), FULL-RANGE STRAIGHT-RUN (benzene < 1% - toluene < 3% - n-hexane < 10% - Flam. Liq. 2)

In case of exposure to intense concentrations of vapours, fumes or spray, transport the person away from the contaminated zone, keep warm and allow to rest. Immediately begin artificial respiration if breathing has ceased. Call a physician immediately.

Symptoms: Inhalation of vapours may cause headache, nausea, vomiting and an altered state of consciousness. May cause irritation of respiratory tract.

Remove contaminated clothing and shoes. Wash skin with soap and water. High pressure injection of the products under the skin may have very serious consequences even though no symptom or injury may be apparent. In this case, the casualty should be sent immediately to hospital. For minor thermal burns, cool the burn. Hold the burned area under cold running water for at least five minutes, or until the pain subsides. Wash off with soap and water.

Symptoms: May cause irritation. Redness.

Rinse thoroughly with plenty of water, also under the eyelids. Check for and remove any contact lenses. Rinse eyes. If eye irritation persists, consult a specialist.

Symptoms: Burning feeling and temporary redness.

Give nothing to drink. Do NOT induce vomiting. as there is high risk of aspiration. The fluid can enter the lungs and cause damage (chemical pneumonitis, potentially fatal). Take victim immediately to hospital. Do not wait for symptoms to develop.

Symptoms: Ingestion may cause gastrointestinal irritation, nausea, vomiting and diarrhoea. May cause central nervous system depression. Aspiration may cause pulmonary oedema and pneumonitis.

Ensure adequate ventilation. Apply technical measures to comply with the occupational exposure limits. . When working in confined spaces (tanks, containers, etc.), ensure that there is a supply of air suitable for breathing and wear the recommended equipment. Do not enter empty storage tanks until measurements of available oxygen have been carried out.

Hydrocarbon-proof gloves for aromatic hydrocarbons. Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion. . Note. gloves made of PVA are not water-resistant, and are not suitable for emergency use. Repeated or prolonged exposure Glove material Glove thickness Break through time Remarks PVA (*) - 480 min EN 374 (*) all layer thickness Fluorinated rubber (*) - 480 min EN 374 (*) all layer thickness Nitrile rubber - 0.5 mm - 480 min EN 374 In case of contact through splashing: Glove material Glove thickness Break through time Remarks Nitrile rubber - 0.3 mm - 60 min EN 374

If splashes are likely to occur, wear:. Safety glasses with side-shields. or. Face-shield.

In case of insufficient ventilation wear suitable respiratory equipment. To enter tankers, tanks, reservoirs where the oxygen content is too low, wear insulating respiratory apparatus. . In an emergency or for exceptional short-lasting jobs in an atmosphere polluted by the product, it is necessary to wear a protective respiratory equipment. When using a mask or half mask :. Full face piece respirator with organic vapor/acid gas cartridge or canister. Type AX. The use of breathing apparatus must comply strictly with the manufacturer's instructions and the regulations governing their choices and uses.

Wear suitable protective clothing. hydrocarbon-proof clothing. Protective shoes or boots.

The product should not be allowed to enter drains, water courses or the soil.