NextSDS Logo
Safety Data Sheet EN

Derakane Momentum™ 411-350 epoxy vinyl ester resin

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
Derakane Momentum™ 411-350 epoxy vinyl ester resin

Regulatory Identifiers

CAS Number
N/A

Manufacturers & Suppliers

A

Ashland

manufacturer

P.O. Box 2219, Columbus, OH 43216, United States of America

614-790-3333

Emergency Contacts

Ashland

1-800-ASHLAND (1-800-274-5263)

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Flam. Liq. Cat. 3
Combustible Dust
Skin Irrit. Cat. 2
Eye Irrit. Cat. 2A
STOT SE Cat. 3
STOT RE Cat. 1

GHS Pictograms

GHS02 - Flammable

GHS02

GHS07 - Health hazard

GHS07

GHS08 - Serious health hazard

GHS08

Hazard Statements

EUH201 May form combustible dust concentrations in air.
H226 Flammable liquid and vapor.
H315 Causes skin irritation.
H319 Causes serious eye irritation.
H335 May cause respiratory irritation.
H372 Causes damage to organs (Auditory system) through prolonged or repeated exposure if inhaled.

Precautionary Statements

P210 Keep away from heat/sparks/open flames/hot surfaces. - No smoking.
P233 Keep container tightly closed.
P240 Ground/bond container and receiving equipment.
P241 Use explosion-proof electrical/ ventilating/ lighting/ equipment.
P242 Use only non-sparking tools.
P243 Take precautionary measures against static discharge.
P261 Do not breathe dust/ fume/ gas/ mist/ vapors/ spray.
P264 Wash skin thoroughly after handling.
P270 Do not eat, drink or smoke when using this product.
P271 Use only outdoors or in a well-ventilated area.
P280 Wear protective gloves/ eye protection/ face protection.
P303 + P361 + P353 IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower.
P304 + P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or doctor/ physician if you feel unwell.
P314 Get medical advice/ attention if you feel unwell.
P332 + P313 If skin irritation occurs: Get medical advice/ attention.
P337 + P313 If eye irritation persists: Get medical advice/ attention.
P338 Remove contact lenses, if present and easy to do. Continue rinsing.
P351 IF IN EYES: Rinse cautiously with water for several minutes.
P362 + P364 Take off contaminated clothing and wash before reuse.
P370 + P378 In case of fire: Use dry sand, dry chemical or alcohol-resistant foam to extinguish.
P403 + P233 Store in a well-ventilated place. Keep container tightly closed.
P403 + P235 Store in a well-ventilated place. Keep cool.
P405 Store locked up.
P501 Dispose of contents/ container to an approved waste disposal plant.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

Static Accumulator, Aspiration hazard, Defatter

Chemical Name CAS Number Concentration Hazardous
STYRENE 100-42-5 43.96% Yes
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Move to fresh air. IF INHALED: Call a POISON CENTER or doctor/ physician if you feel unwell. Keep patient warm and at rest. If unconscious place in recovery position and seek medical advice.

Symptoms: irritation (nose, throat, airways), May cause respiratory irritation.

Skin contact

Remove contaminated clothing. If irritation develops, get medical attention. If on skin, rinse well with water. Wash contaminated clothing before re-use. If on clothes, remove clothes.

Symptoms: Causes skin irritation.

Eye contact

Immediately flush eye(s) with plenty of water. Remove contact lenses. Protect unharmed eye.

Symptoms: Causes serious eye irritation.

Ingestion

Obtain medical attention. Do not give milk or alcoholic beverages. Never give anything by mouth to an unconscious person. If symptoms persist, call a physician.

Symptoms: stomach or intestinal upset (nausea, vomiting, diarrhea)

Immediate Medical Attention

Call a POISON CENTRE or doctor/physician if exposed or you feel unwell.

Medical Treatment

No hazards which require special first aid measures.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. Water spray, Foam, Alcohol-resistant foam, Carbon dioxide (CO2), Dry chemical

Unsuitable media

High volume water jet. Do not use a solid water stream as it may scatter and spread fire.

Specific hazards

Organic dusts at sufficient concentration can form explosive mixtures in air. Never use welding or cutting torch on or near drum (even empty) because product (even just residue) can ignite explosively. Beware of vapours accumulating to form explosive concentrations. Vapours can accumulate in low areas. Polymerization will take place under fire conditions. If polymerization occurs in a closed container, there is a possibility it will rupture violently.

Instructions

Product is compatible with standard fire-fighting agents. Use a water spray to cool fully closed containers. Cool storage container with water, if exposed to fire.

Firefighter Protection

In the event of fire, wear self-contained breathing apparatus.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Evacuate personnel to safe areas. Remove all sources of ignition. Use personal protective equipment. Ensure adequate ventilation. Beware of vapours accumulating to form explosive concentrations. Vapours can accumulate in low areas. Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed.

Environmental

Prevent product from entering drains. Prevent further leakage or spillage if safe to do so. If the product contaminates rivers and lakes or drains inform respective authorities.

Cleanup methods

collect with non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite) and place in container for disposal according to local / national regulations (see section 13).

Materials: non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite)

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Open drum carefully as content may be under pressure. Avoid formation of aerosol. Do not breathe vapours/dust. Do not smoke. Container hazardous when empty. Take precautionary measures against static discharges. Avoid exposure - obtain special instructions before use. Avoid contact with skin and eyes. Smoking, eating and drinking should be prohibited in the application area.

Storage

Keep container tightly closed in a dry and well-ventilated place. Containers which are opened must be carefully resealed and kept upright to prevent leakage. Observe label precautions. No smoking.

Hygiene

Smoking, eating and drinking should be prohibited in the application area. Maintain good housekeeping.

Fire prevention

Do not smoke. Take precautionary measures against static discharges.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below exposure guidelines (if applicable) or below levels that cause known, suspected or apparent adverse effects. Provide appropriate exhaust ventilation at places where dust is formed.

Hands

The suitability for a specific workplace should be discussed with the producers of the protective gloves. Discard gloves that show tears, pinholes, or signs of wear. Wear resistant gloves (consult your safety equipment supplier).

Eyes

Wear chemical splash goggles when there is the potential for exposure of the eyes to liquid, vapor or mist.

Respiratory

In the case of vapour formation use a respirator with an approved filter. A NIOSH-approved air-purifying respirator with an appropriate cartridge and/or filter may be permissible under certain circumstances where airborne concentrations are expected to exceed exposure limits (if applicable) or if overexposure has otherwise been determined. Protection provided by air-purifying respirators is limited. Use a positive pressure, air-supplied respirator if there is any potential for uncontrolled release, exposure levels are not known or any other circumstances where an air-purifying respirator may not provide adequate protection.

Skin/Body

Wear as appropriate: impervious clothing, Safety shoes, Flame-resistant clothing, Choose body protection according to the amount and concentration of the dangerous substance at the work place.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Odor Threshold
No data available
Solubility
Water solubility : insoluble Solubility in other solvents : No data available
Partition Coefficient
No data available
Upper Explosive Limit
6.1 % (V)
Ph
No data available
Flammability
May form combustible dust concentrations in air (during processing). Static Accumulating liquid
Cloud Point
---
Physical State
liquid
Evaporation Rate
< 1
Colour
light yellow
Melting Point
---
Density
1.078 g/cm³ (20 °C)
Freezing Point
---
Decomposition Temperature
No data available
Kinematic Viscosity
> 20.5 mm²/s (40 °C)
Lower Explosive Limit
1.1 % (V)
Relative Evaporation Rate
---
Appearance
liquid
Relative Density
No data available
Solubility In Fat
---
Colour Intensity
---
Solubility In Water
insoluble
Dynamic Viscosity
No data available
State Under Standard Conditions
---
Crystallisation Point
---
Softening Point
---
Molecular Weight
---
Vapor Pressure
0.853 kPa (25 °C)
Bulk Density
---
Voc Content
---
Explosive Limits
---
Solidification Point
---
Properties Status
---
Form
---
Auto Ignition Temperature
---
Physical State Data
liquid
Vapor Density
---
Odor
pungent
Boiling Point
293 °F / 145 °C
Flash Point
84.9 °F / 29.4 °C
Metal Corrosion
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under recommended storage conditions.

Reactivity

No decomposition if stored and applied as directed.

Hazardous reactions

Hazardous polymerisation may occur. Vapours may form explosive mixture with air. This product does not present a dust explosion hazard as delivered. However, fine dust dispersed in air in sufficient concentrations, and in the presence of an ignition source, is a potential dust explosion hazard.

Avoid

Heat, flames and sparks. excessive heat. Exposure to air. Exposure to sunlight.

Incompatible

Acids, aluminum, aluminum chloride, Bases, Copper, Copper alloys, halogens, iron chloride, metal salts, Oxidizing agents, Peroxides

Decomposition

carbon dioxide and carbon monoxide, Hydrocarbons

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

Disposal

Send to a licensed waste management company.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
1866
Shipping Name
Resin solution
Transport Class
3
Packing Group
III
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for Derakane Momentum™ 411-350 epoxy vinyl ester resin?

The signal word is danger.

What is the physical form of Derakane Momentum™ 411-350 epoxy vinyl ester resin?

Derakane Momentum™ 411-350 epoxy vinyl ester resin is a liquid appearing as liquid with light yellow color. It has pungent odor.

What is the solubility of Derakane Momentum™ 411-350 epoxy vinyl ester resin?

Water solubility : insoluble Solubility in other solvents : No data available

What are the hazard statements for Derakane Momentum™ 411-350 epoxy vinyl ester resin?

This substance has 6 hazard statements:

  • EUH201: May form combustible dust concentrations in air.
  • H226: Flammable liquid and vapor.
  • H315: Causes skin irritation.
  • H319: Causes serious eye irritation.
  • H335: May cause respiratory irritation.
  • H372: Causes damage to organs (Auditory system) through prolonged or repeated exposure if inhaled.