GARDOBOND R 2600 E27 (BULK)

Immediate medical attention required. Remove the affected individual into fresh air and keep the person calm. If breathing is irregular or stopped, administer artificial respiration.

Flush with copious amounts of water for at least 15 minutes. Remove contaminated clothing immediately and clean before re-use or dispose it if necessary. Immediate medical attention required. Apply calcium gluconate gel.

Symptoms: allergic symptoms, skin corrosion

Remove contact lenses, if present. Immediately wash affected eyes for at least 15 minutes under running water with eyelids held open, consult an eye specialist. Immediate medical attention required.

Summon medical aid without delay. Keep at rest. Immediately rinse mouth and then drink milk or a magnesium hydroxide/calcium carbonate suspension, do not induce vomiting, seek medical attention.

Symptoms: May cause severe burns of the mouth and throat if orally ingested, as well as a danger of perforation of the oesophagus and the stomach.

carbon dioxide, alcohol-resistant foam, dry powder, water spray

water jet

fluorinated compounds, phosphorus oxides

Cool closed containers in the vicinity of the source of fire.

Avoid breathing vapours. For non-emergency personnel: Use personal protective clothing. Ensure adequate ventilation. Keep away from sources of ignition. For emergency responders: Advice on product handling can be found in sections 7 and 8 of this safety data sheet. Information regarding personal protective measures, see section 8.

Do not allow to enter drains or waterways. Do not discharge into the subsoil/soil.

Contain and collect spillage with non-combustible absorbent materials. Clean preferably with a detergent; avoid the use of solvents.

Materials: non-combustible absorbent materials (sand, earth, vermiculite, diatomaceous earth), detergent

Provide good ventilation of working area (local exhaust ventilation if necessary). Do not return residues to the storage containers. Smoking, eating and drinking are forbidden in application area. Avoid inhalation of vapour and spray mist. The workplace should be equipped with an emergency shower and eye-rinsing facility. Avoid contact with the skin, eyes and clothing. Handle in accordance with good industrial hygiene and safety practice.

Keep container dry. Keep in a cool, well-ventilated place. Avoid direct sunlight. Store only in corrosion proof containers. Close containers carefully once opened and store them upright in order to prevent any leakage. No smoking. No admission for unauthorised personnel. Always keep in containers of same material as the original one. Observe label precautions. avoid contact with metals Store protected against freezing.

Smoking, eating and drinking are forbidden in application area. The workplace should be equipped with an emergency shower and eye-rinsing facility. Handle in accordance with good industrial hygiene and safety practice.

The relevant fire protection measures should be noted.

Ensure adequate ventilation. This can be achieved by the use of local exhaust ventilation and good general extraction.

Chemical resistant protective gloves (EN ISO 374-1); chloroprene rubber (CR) - 0.5 mm coating thickness; butyl rubber (butyl) - 0.7 mm coating thickness; nitrile rubber (NBR) - 0.4 mm coating thickness; Performance level 6, corresponding to a breakthrough time of >480 min according to EN ISO 374-1. The protection glove should be tested for its specific suitability (e.g. mechanical strength, product compatibility, anti-static properties). The gloves should be replaced immediately in case of damage or signs of wear. It is recommended to use preventative skin protection (skin cream).

Tightly fitting safety goggles (splash goggles) (e.g. EN 166)

Respiratory protection required if exposure limit (if available) may be exceeded (Gas filter EN 14387 B). If these are not sufficient to maintain concentrations at the workplace below the occupational exposure limits, appropriate certified respirators must be worn.

Chemical resistant protective clothing according to DIN EN 13034 (Type 6)

The product is stable if stored and handled as prescribed/indicated.

No hazardous reactions if stored and handled as prescribed/indicated. Corrosion to metals: Corrosive effect on metals.

Reacts with metals, with evolution of hydrogen.

Avoid direct sunlight. Avoid freezing. avoid contact with metals

metal, glass, Keep away from highly acidic or alkaline substances as well as oxidants in order to prevent exothermal reactions.

When exposed to high temperatures hazardous decomposition products such as carbon monoxide, carbon dioxide, smoke, oxides of nitrogen may be produced., No hazardous decomposition products if stored and handled as prescribed/indicated.

Do not discharge into drains/surface waters/groundwater. Observe national and local legal requirements.

None known