NextSDS Logo
Safety Data Sheet EN

LOCTITE ABLESTIK FS 163-H known as TRA-BOND FS163-H

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
LOCTITE ABLESTIK FS 163-H known as TRA-BOND FS163-H
Product Code
1446024

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Hardener

Uses advised against

None identified

Manufacturers & Suppliers

Henkel Corporation logo

Henkel Corporation

manufacturer

One Henkel Way, Rocky Hill, Connecticut 06067

+1 (860) 571-5100

http://www.henkelna.com

Emergency Contacts

Poison Control Center

1-877-671-4608

Poison Control Center

1-303-592-1711

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Skin Corr. Cat. 1B
Eye Dam. Cat. 1
Skin Sens. Cat. 1

GHS Pictograms

GHS05 - Corrosive

GHS05

GHS07 - Health hazard

GHS07

Hazard Statements

H314 CAUSES SEVERE SKIN BURNS AND EYE DAMAGE.
H317 MAY CAUSE AN ALLERGIC SKIN REACTION.

Precautionary Statements

P261 Avoid breathing vapors, mist, or spray.
P264 Wash affected area thoroughly after handling.
P272 Contaminated work clothing should not be allowed out of the workplace.
P280 Wear protective gloves, clothing, eye and face protection.
P301 + P330 + P331 IF SWALLOWED: Rinse mouth.
P304 + P341 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing.
P310 Immediately call a POISON CENTER or physician.
P331 Do NOT induce vomiting.
P333 + P313 If skin irritation or rash occurs: Get medical attention.
P338 Remove contact lenses, if present and easy to do. Continue rinsing.
P351 IF IN EYES: Rinse cautiously with water for several minutes.
P361 If on skin (or hair): Take off immediately all contaminated clothing.
P363 Wash contaminated clothing before reuse.
P405 Store locked up.
P501 Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Polyamide --- 80 - 100% Yes
3,6-diazaoctanethylenediamin 112-24-3 5 - 10% Yes

IDH number: 1446024 Product name: LOCTITE ABLESTIK FS 163-H known as TRA-BOND FS163-H

Notes

* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Move to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.

Skin contact

Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothing and footwear. Wash clothing before reuse.

Eye contact

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes.

Ingestion

DO NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person.

Immediate Medical Attention

Get medical attention.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Water spray (fog), foam, dry chemical or carbon dioxide.

Specific hazards

Closed containers may rupture (due to build up of pressure) when exposed to extreme heat.

Instructions

In case of fire, keep containers cool with water spray.

Firefighter Protection

Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel.

Environmental

Do not allow product to enter sewer or waterways.

Cleanup methods

Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Scrape up as much material as possible.

Materials: inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust)

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Use only with adequate ventilation. Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. Refer to Section 8.

Storage

Store at or below 25 °C (77°F). Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use. Keep container dry.

Hygiene

Wash thoroughly after handling.

Fire prevention

Keep in a cool, well ventilated area away from heat, sparks and open flame.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Properties Status
---
Appearance
---
Softening Point
---
Lower Explosive Limit
Not available.
Evaporation Rate
Not determined
Physical State
Liquid
Form
---
Solubility In Water
Soluble
Kinematic Viscosity
---
Metal Corrosion
---
Solidification Point
---
Voc Content
< 1 g/l
Colour
Amber
Density
---
Vapor Pressure
Not determined
Solubility In Fat
---
Upper Explosive Limit
Not available.
Auto Ignition Temperature
Not determined
Flash Point
>250 °C (>482°F)
Boiling Point
Not determined
Vapor Density
Not determined
Physical State Data
liquid
Explosive Limits
---
Dynamic Viscosity
---
Relative Density
0.97
Freezing Point
---
Melting Point
Not determined
Bulk Density
---
State Under Standard Conditions
---
Odor Threshold
Not available.
Ph
Not determined
Flammability
Not applicable
Relative Evaporation Rate
---
Odor
Ammonia
Solubility
---
Crystallisation Point
---
Cloud Point
---
Decomposition Temperature
Not available.
Molecular Weight
---
Partition Coefficient
Not applicable
Colour Intensity
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal conditions of storage and use.

Reactivity

Not available.

Hazardous reactions

Will not occur.

Avoid

Elevated temperatures. Heat, flames, sparks and other sources of ignition. Store away from incompatible materials.

Incompatible

Strong oxidizing agents. Strong acids.

Decomposition

Oxides of carbon. Hydrocarbons. Irritating and toxic gases or fumes may be released during a fire.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
3082
Shipping Name
Environmentally hazardous substance, liquid, n.o.s. (Polyamide resin)
Transport Class
9
Packing Group
III
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for LOCTITE ABLESTIK FS 163-H known as TRA-BOND FS163-H?

The signal word is danger.

What is the physical form of LOCTITE ABLESTIK FS 163-H known as TRA-BOND FS163-H?

LOCTITE ABLESTIK FS 163-H known as TRA-BOND FS163-H is a liquid with amber color. It has ammonia odor.

What is LOCTITE ABLESTIK FS 163-H known as TRA-BOND FS163-H used for?

Hardener

What are the hazard statements for LOCTITE ABLESTIK FS 163-H known as TRA-BOND FS163-H?

This substance has 2 hazard statements:

  • H314: CAUSES SEVERE SKIN BURNS AND EYE DAMAGE.
  • H317: MAY CAUSE AN ALLERGIC SKIN REACTION.

What is the melting point of LOCTITE ABLESTIK FS 163-H known as TRA-BOND FS163-H?

The melting point is Not determined and the boiling point is Not determined.