PRI CHEESE & CHILLI (NHFSS)

Remove victim to fresh air and keep at rest in a position comfortable for breathing.

Remove/take off immediately all contaminated clothing. Rinse skin with water/shower.

Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.

Rinse mouth. Do NOT induce vomiting.

Water, CO2 or Foam

Avoid water in straight hose stream; will scatter and spread fire.

Cool containers exposed to flames with water until well after the fire is out.

Contain spillages with sand, earth or any suitable adsorbent material.

Dike for large spills.

There must be no release into the environment.

Collect with non-combustible absorbent material. Flush with water.

Materials: non-combustible absorbent material.

Do not breathe vapor from heated material.

Store in a cool, dry place with adequate ventilation. Keep away from high temperatures.

Extinguish all ignition sources. Avoid sparks, flames, heat and smoking. Keep away from open flames, and high temperatures.

Use in a well-ventilated area. In the event that ventilation is not sufficient to prevent inhalation of substances or reduce airborne concentrations below an established occupational exposure limit, use an adequate respiratory apparatus to supplement the engineering measures already in place.

Use chemical resistant gloves in accordance with Standard EN 374 for protective gloves against chemicals. When prolonged or frequently repeated contact may occur, a glove with a protection class of 4 or higher (breakthrough time greater than 120 minutes according to Standard EN 374) is recommended. When only brief contact is expected, a glove with a protection class of 1 or higher (breakthrough time greater than 10 minutes according to Standard EN 374) is recommended. Thickness > or = 0.2 mm. Please observe the instructions regarding permeability and breakthrough time which are provided by the glove supplier. Permeation time must exceed contact time. Choose the type of gloves according to the chemical properties of the products being handled. Change gloves according to the manufacturer's recommendations or if they are damaged.

Use safety glasses or a face shield according to Standard EN 166 and according to the hazard analysis specific to the workplace (chemical to be handled, protocol for use, frequency of use, quantity used, etc.).

Use in a well-ventilated area. In the event that ventilation is not sufficient to prevent inhalation of substances or reduce airborne concentrations below an established occupational exposure limit, use an adequate respiratory apparatus to supplement the engineering measures already in place. These recommendations must be adapted according to the hazard analysis specific to the workplace.

Wear protective clothing covering the arms and legs. Use an apron or full suit if exposure is expected. These recommendations must be adapted according to the hazard analysis specific to the workplace.

Stable under normal temperature conditions and recommended use.

Keep away from incompatible materials, open flames, and high temperatures.

Do not release into the environment. Confirm disposal procedures with environmental engineer and local regulations.

Confirm disposal procedures with environmental engineer and local regulations.