Test ink 30 - 56 mN/m

Fresh air. Immediately call in physician. If breathing stops: perform immediately artificial ventilation. Oxygen if necessary.

Remove all contaminated pieces of clothing, immediately. Wash off with water /shower. Consult a physician.

Rinse out with plenty of water. Call in ophthalmologist. Remove contact lenses.

Immediately make victim drink water (two glasses at most). Consult a physician.

Carbon dioxide (CO₂), foam, dry powder, water.

For this substance/mixture no irritations of extinguishing agents are given.

Combustible. Vapours are heavier than air and may spread along floors. Forms explosive mixtures with air at elevated temperatures.

Remove container from danger zone and cool with water.

Do not inhale vapours/aerosols. Avoid substance contact. Ensure adequate ventilation. Keep away from heat and sources of ignition. Evacuate the danger area, observe emergency procedures, consult an expert.

Do not allow to enter into drain. Risk of explosion.

Take up carefully with liquid-absorbent material (e.g. Chemizorb®). Dispose of properly. Clean up affected area.

Materials: liquid-absorbent material (e.g. Chemizorb®)

Work under hood. Do not inhale substance / mixture. Avoid generation of vapours/aerosols.

Keep locked up in an area accessible only for qualified or authorized persons. Keep container tightly closed in a dry and well-ventilated place.

Immediately change contaminated clothing. Apply preventive skin protection. Wash hands and face after working with substance.

Keep away from open flames, hot surfaces and sources of ignition.

Full contact: Material: butyl-rubber, Minimum layer thickness: 0.7 mm, Break through time: 480 min, Material tested: Butoject® (KCL 898). Splash contact: Material: Viton®, Minimum layer thickness: 0.7 mm, Break through time: 240 min Material tested: Vitoject® (KCL 890 / Aldrich Z677698, Size M). This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN16523-1 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de).

Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Safety glasses.

Recommended filter type: Filter A (acc. to DIN 3181) for vapours of organic compounds. The entrepreneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.

Flame retardant antistatic protective clothing.

Do not empty into drains. Risk of explosion.

The product is chemically stable under standard ambient conditions (room temperature). Contains the following stabilizer(s): Butyl hydroxytoluene (BHT) (0,005%)

Vapour/air-mixtures are explosive at intense warming.

A risk of explosion and/or of toxic gas formation exists with the following substances: Air. Risk of ignition or formation of inflammable gases or vapours with: Light metals, aluminum. Violent reaction possible with: Oxidising agents, bases, zinc. Risk of explosion with: Furfuryl alcohol, oxides of phosphorus, hydrogen peroxide, iodine, pyridine, sulphur trioxide. A risk of explosion and/or of toxic gases exists with the following substances: Water separating agents.

May form peroxides on contact with air. Heating

Copper, light metals, aluminum.

Hydrogen cyanide (hydrocyanic acid)